Belt Drive Blower Motors

When working on your belt drive blower unit, please follow all safety procedures.  Make sure that the power is shut off at circuit breaker.

Belt drive blowers have several working parts.  The motor will be attached to the outside of the blower housing, most commonly bolted to a rubber isolated plate.  The motor can be removed by simply detaching it from its mounting plate,  disconnecting the power leads and slipping the belt off of the pulley.  If the parts of the blower are damaged however, you may need our assistance.  The shaft will need to be removed from the blower wheel and most likely replaced along with the bearings.  It is highly recommended to have us work on your belt drive assembly in our shop.  Be advised, you may have to leave it with us for up to a full day.

Motor information that we need over the phone:

• Horsepower
• RPM
• Voltage
• Amperage
• Frame size
• Manufacturer name and model number

Blower wheel information that we need  over the phone:

• Wheel diameter
• Wheel width
• Shaft size

Parts that we can provide for this application:

Motor, wheel, housing, entire blower assembly, shaft, bearings, pulleys, belts, thrust collars, bearing brackets, mounting hardware

>>>  ADDITIONAL INSTALLATION, ADJUSTMENT AND SERVICE TIPS  <<<